JoyOne factory · material calculator

Pea Gravel Calculator

Smooth 3/8-inch stone, sold by the yard in bulk and by the 50 lb bag at the hardware store. Both numbers come out of the same two measurements.

Paths and bedsDog runsTree ringsBulk or bagged

Material calculator

Material
Gravel and stone
Area 1 · Rectangle

Beds, lawns, parking pads — anything with square corners.

0.49 cubic yards to buy 13.3 cu ft · 0.53 short tons · 27 bags of 0.5 cu ft
+13
Volume
13.3 ft³
Cubic yards
0.49 yd³
Cubic metres
0.38 m³
Weight
1,067 lb
Short tons
0.53
Metric tonnes
0.48 t

80 ft² of ground × 2 in average depth ÷ 12 = 13.33 ft³

13.33 ft³ × 80 lb/ft³ (Pea gravel) = 1,067 lb

0.49 yd³ to buy, 27 bags

Type a price above to see a material total.

Bulk density 80 lb/ft³, published range 75–85. Wet material weighs more; your supplier's figure wins.

Area by area (1)
#ShapeMeasurementsDepthAreaVolume
1 Rectangle 20 × 4 ft 2 in 80 ft² 13.33 ft³

Worked examples

Every number below is produced by the same engine that runs in the browser, at build time — so the examples cannot drift from the calculator above.

Pea gravel, three ways — computed by this page's engine at build time
ScenarioMaterialVolumeCubic yardsShort tonsMetric tonnesBags
20 × 4 ft path, 2 in deep Pea gravel 13.33 ft³ 0.49 yd³ 0.53 0.48 27 bags of 0.5 cu ft
10 × 10 ft dog run, 3 in deep Pea gravel 25 ft³ 0.93 yd³ 1 0.91 40 bags of 50 lb
36 in tree ring with an 8 in trunk, 2 in deep Pea gravel 1.12 ft³ 0.04 yd³ 0.04 0.04 3 bags of 0.5 cu ft

What pea gravel is, and what it is not

Pea gravel is small, rounded, water-worn stone, usually around three eighths of an inch across. It is comfortable underfoot and it does not compact into a hard surface, which is why it belongs on paths, in beds, around trees, in dog runs and under swing sets — and why it is a poor choice for a driveway, where rounded stones roll instead of locking.

The angular alternative is crushed stone, sold by size class: #57 for a driveway base, #411 for a surface that firms up, #3 for the bottom lift. If you are building something that a car has to drive on, the driveway page is the one you want. If you are filling a bed or edging a path, rounded pea gravel is the right material and this page is the right calculator.

The page also handles river rock, which behaves the same way at a similar bulk density and is often quoted interchangeably for beds and dry creek beds.

How deep should pea gravel go?

Two inches is the depth most paths and beds start from: enough to cover the soil and hold a colour, thin enough that a wheelbarrow does not bog down. Three inches is better on a dog run or anywhere the stone will be kicked around, because the layer stays covered after the top inch is displaced.

When pea gravel is being used as a mulch substitute — a topdressing over soil around plants — University of Maryland Extension puts gravel, stone and lava rock in a 1-inch layer, thinner than bark mulch, because stone does not need the depth that organic mulch does to suppress weeds and hold moisture.

For a playground, the number is not a preference: CPSC Publication 325, Table 2 lists 9 inches of pea gravel as protecting to a fall height of 5 feet. The playground page quotes that table in full and explains the compression allowance that goes with it.

Coverage per ton and per bag

At the 80 lb/ft³ in the table, one short ton of pea gravel is 2,000 ÷ 80 = 25 cubic feet. Spread 2 inches deep, 25 cubic feet covers 150 square feet; at 3 inches it covers 100 square feet. That is the whole coverage table, and it is why the tonnage and the area have to be worked out together rather than guessed independently.

A 50 lb bag is 50 ÷ 80 = 0.625 cubic feet, which covers 3.75 square feet at 2 inches. Bagged pea gravel is convenient for a tree ring and painful for a path: a 20 × 4 ft path at 2 inches needs 13.3 cubic feet, which is 27 bags of 0.5 cubic feet, or roughly 0.5 cubic yards in bulk.

The examples above run these numbers through the same engine the form uses, including the bag count, which is always rounded up — you cannot buy two thirds of a bag.

Edging, slopes and weeds

Loose rounded stone migrates. On any edge that meets soil, grass or a driveway, hold it with steel or aluminium edging set below the surface, or with a shallow trench and a firm border. Without an edge, the stone creeps into the lawn a few inches a year and the path thins at the same rate.

Slopes are the other constraint: pea gravel on anything steeper than a gentle grade slides, and a path on a hill needs steps or a stabilised binder rather than more stone. On flat ground over bare soil, a woven geotextile under the stone keeps soil from pumping up into the layer and keeps the depth you paid for.

Weed fabric under gravel stops most weeds but also stops leaves and grit from disappearing into the soil, so the top of the stone collects debris over time. It is a trade, not a free win, and it is easier to decide before the stone arrives than after.

Ordering: bulk, bag or half-and-half

Bulk is cheaper per cubic foot and the only sensible way to buy more than about a cubic yard, but it arrives as a pile on the street and it has to be moved. Bagged material costs more per cubic foot and can be carried to the spot where it is needed. The usual compromise is bulk for the body of the job and a few bags for the last wheelbarrow.

Ask for washed pea gravel if the stone is going where people walk barefoot or where drainage matters; unwashed stone brings fines that turn to mud in the first rain. Ask for the density your supplier actually uses if the tonnage has to match a quote — the field on this page accepts it.

Questions this page answers

How much does a yard of pea gravel cover?

One cubic yard is 27 cubic feet. At 2 inches deep that covers 162 square feet; at 3 inches, 108 square feet; at 1 inch, 324 square feet. Divide 27 by the depth in feet to get coverage in square feet.

How many 50 lb bags are in a cubic yard of pea gravel?

A cubic yard weighs about 2,160 lb at the 80 lb/ft³ used here, which is 44 bags of 50 lb. Bagged pea gravel usually comes in 0.5 cubic foot bags instead, and those run to 54 bags per yard.

Is pea gravel good for a dog run?

It is one of the usual choices: rounded, so it does not cut paws, and loose, so it drains and hoses off. Three inches is a better starting depth than two, and the run needs an edge to keep the stone in. Puppies and small dogs can still move it, so check the surface before you let them out.

Can I put pea gravel over soil without removing the grass?

You can, but the grass will come through unless it is dead or covered. Strip it, or lay a woven geotextile over the soil first, then place the stone at the depth you calculated. A 1-inch layer over living grass is a losing proposition either way.

Is pea gravel safe under a swing set?

CPSC Table 2 lists 9 inches of pea gravel as protecting to a 5-foot fall height, which is lower than the fall heights the same table allows for wood chips or shredded rubber. Follow the handbook and the equipment manufacturer, and keep the depth topped up — loose fill is displaced fastest under swings and at slide exits. This calculator does not certify a playground as safe.

Quantity estimate only. Bulk density varies with moisture and gradation, compaction removes depth from a lift, and the depths quoted for playground surfacing come from CPSC Publication 325 for the material and fall height stated there. Check the CPSC handbook and your equipment manufacturer; this calculator does not certify safety. Nothing you type is uploaded.