JoyOne factory · material calculator

57 Gravel Calculator

Number 57 is the workhorse crushed stone: a single washed size that drains, locks under load and shows up in almost every driveway quote.

Washed crushed stoneDriveway baseFrench drainsYards, tons, bags

Material calculator

Material
Gravel and stone
Area 1 · Rectangle

Beds, lawns, parking pads — anything with square corners.

3.11 cubic yards to buy 84 cu ft · 3.78 short tons · 168 bags of 0.5 cu ft
+154
Volume
84 ft³
Cubic yards
3.11 yd³
Cubic metres
2.38 m³
Weight
7,560 lb
Short tons
3.78
Metric tonnes
3.43 t

240 ft² of ground × 4 in average depth ÷ 12 = 80 ft³

80 ft³ × 90 lb/ft³ (#57 stone) = 7,560 lb

+5% waste → 3.11 yd³ to buy, 168 bags

Type a price above to see a material total.

Bulk density 90 lb/ft³, published range 85–95. Wet material weighs more; your supplier's figure wins.

Area by area (1)
#ShapeMeasurementsDepthAreaVolume
1 Rectangle 20 × 12 ft 4 in 240 ft² 80 ft³

Worked examples

Every number below is produced by the same engine that runs in the browser, at build time — so the examples cannot drift from the calculator above.

Three #57 jobs — computed by this page's engine at build time
ScenarioMaterialVolumeCubic yardsShort tonsMetric tonnesBags
20 × 12 ft driveway lift at 4 in #57 crushed stone 80 ft³ 2.96 yd³ 3.6 3.27 160 bags of 0.5 cu ft
40 ft French drain trench, 18 in wide, 18 in deep #57 crushed stone 90 ft³ 3.33 yd³ 4.05 3.67 180 bags of 0.5 cu ft
10 × 3 ft walking path at 2 in #57 crushed stone 5 ft³ 0.19 yd³ 0.23 0.2 9 bags of 50 lb

What #57 stone actually is

Number 57 is a size class of crushed stone — a single, washed grade running from about 1 inch down to the No. 4 sieve, with most of the stone in the middle of that range. Because it is a single size rather than a blend, it does not compact into a firm surface the way a mixed material does; the stones lock against each other and leave voids that drain.

That is exactly why it is the middle course of a gravel driveway, the aggregate around a perforated drain pipe, and the stone under a patio where water has to get away. It is also one of the stones sold for concrete mixes and for muddy gateways that need to stop being muddy.

The crushed stones in this table are given the bulk density of crushed limestone from the reference table: 90 lb/ft³, with an 85 to 95 range. Granite and traprock #57 are similar; if the quarry gives you a number, use theirs.

Where #57 belongs, and where it does not

As a driveway base or middle course, #57 is standard practice: 4 inches over a bottom lift of larger stone, compacted, then a surface course of something with fines in it. As a walking surface on its own it is loose and a little harsh underfoot, and it will move under a wheelbarrow.

As a drainage medium it is close to ideal: washed stone means no fines to clog the pipe, and the voids between the stones carry water. A French drain is a trench of #57 with the pipe near the bottom and geotextile over the top to keep soil out.

As a playground surface, CPSC Table 2 does not list #57 — it lists pea gravel, which is rounded. Angular crushed stone is a different material and should not be substituted on the assumption that "gravel is gravel".

How far a ton or a yard goes

At 90 lb/ft³, one short ton of #57 is 2,000 ÷ 90 = 22.2 cubic feet. At 4 inches deep that covers 66.7 square feet, so a 20 × 12 ft drive at 4 inches needs 80 cubic feet — 3.6 short tons, or 2.96 cubic yards, before an allowance for compaction.

A 0.5 cubic foot bag holds 1/54 of a cubic yard, which is why bagged #57 is only sensible for patching. A single 20 × 12 ft lift at 4 inches is 160 bags.

The three examples above use the same engine as the form, including the driveway example with a 5% waste allowance, so the figures can be checked against the calculator instead of trusted.

Compaction and the finished thickness

Loose #57 at 4 inches is not 4 inches of finished drive. A plate compactor or a plate tamper settles the stone by a noticeable fraction, and traffic keeps settling it. Order for the loose depth you need plus 5 to 10%, and compact in two passes with a light spray of water between them if the stone is very dry.

Check the thickness with a straight edge across the lift rather than by eye. It is much easier to add half an inch of stone now than to explain to a delivery driver why the drive needs another load.

The other sizes in the family

Number 3 is the big bottom stone, 2 to 3 inches, used to bridge soft ground. Number 411 is a mixed grade with fines that compacts into a firm surface, which makes it the usual top course. Number 8 is smaller than #57 and is used for pipe bedding and decorative edges.

Mixing them up is the most common ordering error in a driveway build. If you are unsure which one your project needs, describe the job to the quarry — they will know what the local soil takes and what the local code asks for.

Questions this page answers

How much does a yard of #57 stone weigh?

About 2,430 lb at 90 lb/ft³, which is 1.22 short tons. The published range for crushed stone is 85 to 95 lb/ft³, so a yard can run from 1.15 to 1.28 tons depending on the rock and how wet it is.

How many square feet does a ton of #57 cover?

22.2 cubic feet per ton at 90 lb/ft³. Spread 4 inches deep that is about 67 square feet; at 2 inches, about 133 square feet.

What is #57 stone used for?

Driveway base and middle courses, drainage trenches and French drains, pipe bedding, and anywhere water has to move through the stone. It is a single washed size, so it drains and does not compact into a hard surface.

Is #57 the same as crushed stone?

It is one size class of crushed stone. Crushed stone is the family; #57 is the 1-inch-to-No. 4 grade within it. #3, #8 and #411 are different classes of the same family.

Can I use #57 for a playground?

No. CPSC Table 2 lists pea gravel, not angular crushed stone, and the handbook is specific about the material it tested. Use the playground page and follow the CPSC table.

Quantity estimate only. Bulk density varies with moisture and gradation, compaction removes depth from a lift, and the depths quoted for playground surfacing come from CPSC Publication 325 for the material and fall height stated there. Check the CPSC handbook and your equipment manufacturer; this calculator does not certify safety. Nothing you type is uploaded.