JoyOne factory · material calculator
Mulch Calculator — How Much Mulch Do I Need?
Beds, depth, and the bag size you actually buy. The answer is in cubic yards for a bulk order and in bags for the back of the car.
Material calculator
- Volume
- 25 ft³
- Cubic yards
- 0.93 yd³
- Cubic metres
- 0.71 m³
- Weight
- 375 lb
- Short tons
- 0.19
- Metric tonnes
- 0.17 t
100 ft² of ground × 3 in average depth ÷ 12 = 25 ft³
25 ft³ × 15 lb/ft³ (Bark mulch) = 375 lb
0.93 yd³ to buy, 13 bags
Type a price above to see a material total.
Bulk density 15 lb/ft³, published range 10–20. Wet material weighs more; your supplier's figure wins.
Area by area (1)
| # | Shape | Measurements | Depth | Area | Volume |
|---|---|---|---|---|---|
| 1 | Rectangle | 10 × 10 ft | 3 in | 100 ft² | 25 ft³ |
Worked examples
Every number below is produced by the same engine that runs in the browser, at build time — so the examples cannot drift from the calculator above.
| Scenario | Material | Volume | Cubic yards | Short tons | Metric tonnes | Bags |
|---|---|---|---|---|---|---|
| 10 × 10 ft new bed at 3 in | Bark mulch | 25 ft³ | 0.93 yd³ | 0.19 | 0.17 | 13 bags of 2 cu ft |
| 100 ft of border strip, 3 ft wide, 2 in | Bark mulch | 50 ft³ | 1.85 yd³ | 0.38 | 0.34 | 25 bags of 2 cu ft |
| 20 ft ring around a 12 in trunk, 3 in | Bark mulch | 78.34 ft³ | 2.9 yd³ | 0.59 | 0.53 | 27 bags of 3 cu ft |
How deep should mulch be?
University of Maryland Extension keeps bark mulch at 1 to 3 inches and wood chips in the same range; deeper than that does not suppress more weeds and it does starve the soil of air. Three inches is the depth for a new bed, two inches to refresh a bed that still has a layer, and one inch for a light top-up that restores colour without burying what is there.
The depth is also the number that decides the bill. At 3 inches, 100 square feet needs 25 cubic feet, which is just under a cubic yard. At 2 inches the same bed needs 16.7 cubic feet, and at 1 inch 8.3. Getting the depth right is worth more than shopping around for a cheaper yard.
Where a tree is involved, keep the mulch a few inches away from the trunk. A cone of mulch against the bark — the volcano — holds moisture against the trunk and invites rot and rodents, and it is the most common mulch mistake there is.
Bags against bulk
Bagged mulch is normally sold by volume in 2 cubic foot bags, sometimes 3. A 2 cubic foot bag at 3 inches deep covers 8 square feet; a 3 cubic foot bag covers 12. That is a useful mental scale: a 10 × 10 ft bed at 3 inches is 12.5 bags of 2 cubic feet, or 9 bags of 3.
Bulk mulch is sold by the cubic yard — 27 cubic feet, or 13.5 bags of 2 cubic feet — and it is much cheaper per cubic foot, but it arrives as a pile. The break-even is usually somewhere around half a yard: below that, bags are easier; above it, bulk is cheaper and faster.
The calculator shows both at once, so the decision is about access and price rather than arithmetic. Type your supplier's price per yard, per bag or per ton and the total updates with the quantity.
Refreshing a bed that already has mulch
Old mulch does not disappear; it breaks down and becomes part of the soil. That is the point of it, but it means a refresh needs less than a new bed. Scrape back the old layer with a rake, break up any matted crust, and top up to the depth you want rather than adding a full 3 inches on top of what is there — 1 to 2 inches is usually enough.
If the old mulch has a grey, matted crust, that crust is fungal growth digesting the surface, and it is harmless. Raking it open is enough; it does not need to be removed or replaced.
Mulch in autumn over fallen leaves is mostly a way of hiding them. Leaves break down faster if they are shredded and left, and a thin layer of mulch over shredded leaves keeps the bed looking tidy without smothering it.
Weed fabric, pre-emergents and the honest trade-offs
Fabric under mulch stops weeds for a season or two and then collects soil on top, which is enough for weeds to grow anyway. It also stops organic matter from cycling back into the soil. Most extension guidance is lukewarm about it in beds and positive about it under stone, where the point is separation rather than weed control.
A thick, maintained layer of mulch is the more reliable weed suppressant: 3 inches of bark keeps light off the soil surface, and the weeds that do appear pull easily. Topping up once a year costs less than replacing fabric.
What the bag count does and does not tell you
The count is rounded up from the volume you need, including the waste allowance if you set one. It does not account for how much a bag is compressed in the stack: bags that have settled hold the same volume when broken up, but they look smaller on the pallet, which is why the bag count sometimes surprises people at the register.
The calculator also does not model a delivery minimum, a pallet deposit or a bulk-bag (one cubic yard tote) price, because those are local. It gives you the quantity; the price is yours to type.
Questions this page answers
How many bags of mulch is a cubic yard?
13.5 bags of 2 cubic feet, or 9 bags of 3 cubic feet, because a cubic yard is 27 cubic feet. Bulk is sold by the yard; bags are sold by volume, so the two are directly comparable.
How much does a 2 cubic foot bag of mulch cover?
8 square feet at 3 inches deep, 12 square feet at 2 inches, and 24 square feet at 1 inch. Divide the bag volume by the depth in feet to get coverage.
How deep should mulch be around trees?
1 to 3 inches, kept a few inches back from the trunk. A deep cone against the bark holds moisture on the trunk and can rot it; wide is good, deep is not.
Is it cheaper to buy mulch in bulk or in bags?
Bulk is cheaper per cubic foot once you need more than about half a cubic yard, but it arrives as a pile you have to move. Bags cost more per cubic foot and can be carried to the bed. The quantity is the same either way; the calculator shows both counts.
How often should I add mulch?
Once a year in most beds, at 1 to 2 inches rather than a full new layer, because the old mulch is still there and has partly broken down. New beds start at 3 inches.
Quantity estimate only. Bulk density varies with moisture and gradation, compaction removes depth from a lift, and the depths quoted for playground surfacing come from CPSC Publication 325 for the material and fall height stated there. Check the CPSC handbook and your equipment manufacturer; this calculator does not certify safety. Nothing you type is uploaded.